My Torn Radio Fu, D2, Project.
  • Introduction
  • Materials Required
    • Tools required
    • Replica resin faceplate
    • Replica resin faceplate & Control Knobs & Dials >
      • Dial's & Meter's construction >
        • Construction of Ma Meter
        • Construction of V Meter
        • Tuning dial construction
        • Constructing my Enigma Keys, & plugboard.
        • Fusprech f
        • Constructing the Battery Box for my Torn eb
        • " Abgesetzte Antenne " Remote Ariel for the Torn fu d2
        • My "Entertainment Radio"
      • Aerial input socket & tuning apparatus
      • Front connection panel for Communication's gear
      • Battery power inlet socket
      • power cable
      • 2B 39 Battery
      • External aerial & mounting
      • Sound Box
      • Accessory case's for Radio gear
      • Case for Sturmgewher 44
      • Transporting case for Aerial's
      • Micro switch mounting plate & built in audio source.
      • Morse code circuit.
      • "Radio case" & transporting Strap loops & Side loops,
      • Transporting straps
  • Internal make up of the "Radio"
  • Battery Box
  • Numbers, logos & dials
  • Failed designs
  • Technical " Maintenance " of Radio
  • Comment / Contact / or ask a Question
  • Where am i
  • My Communication's Post
  • Monitoring Receiver Fu.H.E.c.
  • Feldfu f
  • Building my Arriflex 35 mm Camera
  • News Reel
  • Fu.H.E.uL. Radio receiver, Direction Finder
Front panel for Communication's gear.
Picture
Picture
Picture
Picture
Picture
Blank connection strip at rear of faceplate
Picture
Painted panel at rear of connection strips
Picture

Connection strip at rear faceplate for Communications Gear

Picture
Picture
Connections from the left on connection strip,

Morse key, two connectors  on ( White panel )

Michrophone,   group of three,

Earphones,   group of two,

Earphones, group of two,

Opening for plug in point from battery box can be seen to the left,

Picture
Construction of individual plug in connection points,
Construction of surface mounted wire retaining clips. ( follow sequence from one )
This is the rear view of the face plate showing  the plug in point for the Morse key,  the wiring will form part of the Electrical circuit to operate the tone oscillator, which will produce the Morse sound.  
Rear of faceplate, finished plug in connectors & surface wire retaining clips in position.
Picture
measurement of total width of finished clip.
Picture
Repro Microphone
Picture
Picture
Hand Microphone                                                              Earphones's
Picture
Picture
All units in place
Picture
original earth spike.
Picture
close up of connection point for earth wire on spike. 
Picture